HELP!!!!!

[kitnut617]

Lee's way (that's wooksta) is for someone who has done a few, there's too much room for error as you could quite easily cut into the finished part. The way I've shown is for beginners, and once you've done a few then you can figure out what works for you.

Those drawings are just right mate  I now understand the process a lot, lot better then previously when I've just read about it.

I may now get around to a couple of vacforms I have in the stash, thankyou

Chris

No worries Mate!

I just drew it up after reading it in this book below, the author is a very well known vacuform builder.

[NARSES2]

Those drawings are just right mate  I now understand the process a lot, lot better then previously when I've just read about it.

I may now get around to a couple of vacforms I have in the stash, thankyou

Chris

No worries Mate!

I just drew it up after reading it in this book below, the author is a very well known vacuform builder.

Ta. As said I've had the process explained to me a few times but never fully understood it. Now I do