End game - 1/24

[nönöbär]

End game

Those two figures were called "DLP Torture Test" - can the DLP printer print it? I was very skeptical because of those long "tentacles" of the monster.
It worked out much better than I had expected.

And I think it also could have been a discussion between an IT consultant and the customer - the big question is who is who..... ?  (Don't ask me why I think about something like that....)

I added a stand and some bones on the ground.

Printed with an Anycubic Photon, hand painted with Revel Aqua Colour.










The following 3D-Models were used:

DLP Torture Test by Gringoling Mar 13, 2019  (Published on Mar 13, 2019) https://www.thingiverse.com/thing:3489665
Bone Pile - 28mm gaming by ecaroth (Published on Nov 14, 2017) https://www.thingiverse.com/thing:2645297

[NARSES2]

That's come out very well, you're getting good at this 3-D malarkey 

And I think it also could have been a discussion between an IT consultant and the customer - the big question is who is who..... ? 

Well I certainly know where I stood as a customer