BAE Harrier GR7A JASDF Maritime Strike, Finished pics pg 5.

[Wardukw]

Awesome Fred 👌 👏 👍

[DogfighterZen]

That is so good... Love that camo! Great work, mate!    
Fun build, wasn't it? I've built that kit and have good memories of it.

[su27rules]

        Great build!!

[zenrat]

Thanks folks. 

...Fun build, wasn't it? I've built that kit and have good memories of it.

Yes.  It went together fairly well.  But there are a few niggles.  The panel with the LERX behind the cockpit required clamping pressure to get a good fit.  The fuselage seam inside the opening behind the nose gear bay was awkward to fill and clean up.  The two part nozzles are a pain but I couldn't find any resin or 3d printed one piece replacements (I nearly used Hasegawa FRS-1 nozzles but decided to keep them for a RAN FAA build).  The outriggers lifted the main wheels off the ground and had to be shortened.  The sprue attachment points on the opening part of the canopy were tricky to cleanly remove (particularly the front centre) but then there is a seam down the centre which needs sanding and polishing anyway.  Oh, and all the little lumps and bumps are probly better off being glued on before paint than after (but care will have to be taken).
I'd build another.  In RAAF colours.

[Weaver]

Ooh, very pretty...  

[zenrat]

Thanks H.

[DogfighterZen]

Thanks folks. 

...Fun build, wasn't it? I've built that kit and have good memories of it.

Yes.  It went together fairly well.  But there are a few niggles.  The panel with the LERX behind the cockpit required clamping pressure to get a good fit.  The fuselage seam inside the opening behind the nose gear bay was awkward to fill and clean up.  The two part nozzles are a pain but I couldn't find any resin or 3d printed one piece replacements (I nearly used Hasegawa FRS-1 nozzles but decided to keep them for a RAN FAA build).  The outriggers lifted the main wheels off the ground and had to be shortened.  The sprue attachment points on the opening part of the canopy were tricky to cleanly remove (particularly the front centre) but then there is a seam down the centre which needs sanding and polishing anyway.  Oh, and all the little lumps and bumps are probly better off being glued on before paint than after (but care will have to be taken).
I'd build another.  In RAAF colours.

Yes, it does require some care with assembly of a few bits, i remember having the same issue with the LERX part but not with the landing gear... maybe i had it too but didn't think it was from kit...  
Anyway, all minor issues and i'd also build another one but first i wanna build one of the Hasegawa AV-8B+.

[Vulcan7]

Beautiful camo colours & complementary red decals           

[chrisonord]

Marvrelous Fred. 

[zenrat]

Thanks folks,