Babarian Girl, 1/12

[nönöbär]

This is the first attment to print a figure with the SLA Printer.
It almost worked, but the right arm did not come out very well (I guess I used not enough support there). So I had to removed it and reprinted it with the FDM printer - in the end it worked somehow.

Printed with an Anycubic Photon, hand painted with Revel Aqua Colour.






The following 3D-Model was used:

BARBARIAN GIRL by boris3dstudio (Published on May 18, 2019) https://www.thingiverse.com/thing:3639225/

[NARSES2]

The question is : Would I want to meet her on a dark night or not ? 

Nice job

[nönöbär]

The question is : Would I want to meet her on a dark night or not ? 

Nice job

I guess better not.... My engineer was too afraid and did not want to get on the photos.

[NARSES2]