avatar_Robomog

Winans Cigar Ship Realised - HMS Provider

Started by Robomog, March 04, 2025, 02:40:16 AM

Previous topic - Next topic

Rick Lowe


Robomog

#31
Hi all

Finally finished

First a rather sketchy back story then the pics.....

HMS Provider – A Cigar Ship that was asked to do too much

Around 1910 Initial model testing of a cigar ship proved to be quite promising, the central Turbine fan gave it a reasonable turn of speed and with its two opposing rudders it could turn extremely tightly, however it did have a tendency to roll very badly so two streamlined outriggers were added to each side to stabilise the ship  which worked quite successfully.

Eventually a contract was given to build a full size ship and work commenced for a Cigar Ship Destroyer intended to have three four inch guns, two one inch anti aircraft guns, a number of half inch machine guns and torpedo tubes

However many months down the line but  fairly early in its construction the powers that be in the navy changed their minds. New edicts were issued that the navy required a high speed tender to supply current Destroyers at sea with fuel, food and ammunition on an effort to increase their range so that they could stay longer with Atlantic convoys.

As a result of this the Cigar Ship lost all its smaller armament and torpedoes. The rear hull aft of the Turbine was turned into a large hold to carry food and ammunition.  The pontoons were redesigned to carry fuel oil with extra fuel carried large tanks in the hold that could be pumped into the pontoons.

Essentially it became half destroyer and half transport, a jack of all trades but master of none.

The remaining  construction, adaptions and subsequent launch went without problem and HMS Provider was born.

The working up trials followed but started to show some limitations in the design.

Unladen it still had a reasonable turn of speed and manuverability. But when fully loaded the problems began.

The most serious problem was that the ship sat much lower in the water and coupled with increased rolling momentum brought on by the increased weight caused the pontoons to dig in and drag the connecting structure into the sea which in turn pulled the ship towards the pontoon.

The speed was also reduced because of the extra weight and drag so it could not keep up with a normal destroyer even if said destroyer was at an economical cruise.

They tried restricting the amount it could carry but to no avail, it just wasn't up to the job. Plans were made to replace the booms with aircraft style floats or dispense with the pontoons altogether and give it a massive keel but good sense prevailed and the whole project was cancelled.

The ship was taken to Scapa Flow  had all the armament removed and became an oiler and accommodation vessel for destroyers passing through until it was unceremoniously scrapped a few years later, another project the killed by a British disease that tries to get more bang for their bucks and ends up crippling the project.

If they had left the project as originally designed there was a strong chance it would have worked, but fiddling with the design doomed it to failure.


And now the pics....

Being as its a naval subject I've photographed it using a blue background  for a change, I think it came out pretty well.























I don't have any 1/600 scale ships  to do the scale shots  so I've posed the last two photographs with a 1/600 scale Sea Vixen from HMS Victorious





Thanks for looking....

All comments and criticisms gratefully accepted


Mog
>^-.-^<

 

 

Mostly harmless ...............

kerick

That's very original! Looks awesome!
There's a guy at my model club that does RC ships. I'm going to give him a challenge!
" Somewhere, between half true, and completely crazy, is a rainbow of nice colours "
Tophe the Wise

scooter

Quote from: Robomog on Yesterday at 04:49:50 PMThe ship was taken to Scapa Flow  had all the armament removed and became an oiler and accommodation vessel for destroyers passing through until it was unceremoniously scrapped a few years later, another project the killed by a British disease that tries to get more bang for their bucks and ends up crippling the project.

That would be HM Treasury. :wacko: Congress would have given them half the funding (if they were lucky) to do the same thing.

Nice work Moggie
The F-106- 26 December 1956 to 8 August 1988
Gone But Not Forgotten

QuoteOh are you from Wales ?? Do you know a fella named Jonah ?? He used to live in whales for a while.
— Groucho Marx

My dA page: Scooternjng

PR19_Kit

An awesome vessel for sure.  :thumbsup:

I LOVE those four funnels, a magic look.  :wub:
Kit's Rule 1 ) Any aircraft can be improved by fitting longer wings, and/or a longer fuselage
Kit's Rule 2) The backstory can always be changed to suit the model

...and I'm not a closeted 'Take That' fan, I'm a REAL fan! :)

Regards
Kit

Wardukw

Totally original bad idea or a bad idea ...lovely stuff Mog man  :thumbsup:  :thumbsup:
If it aint broke ,,fix it until it is .
Over kill is often very understated .
I know the voices in my head ain't real but they do come up with some great ideas.
Theres few of lifes problems that can't be solved with the proper application of a high explosive projectile .

zenrat

Fred

- Can't be bothered to do the proper research and get it right.

Another ill conceived, lazily thought out, crudely executed and badly painted piece of half arsed what-if modelling muppetry from zenrat industries.

zenrat industries:  We're everywhere...for your convenience..